Clifford Level Four, Руководство по установке

Страница: 7 / 16

2-Stage
(only driver’s door unlocks
upon first press; all doors upon second
press)
1. Find the driver’s-door lock motor
wire in the door or kick panel that
shows +12V when the doors are
unlocked.
2. Cut the wire and activate the switch.
All doors except the driver’s door
should unlock.
3. Connect the WHITE/ORANGE wire
to the motor side of the cut wire and
the GRAY/ORANGE wire to the
switch side.
4. Connect the RED/ORANGE wire to
+12V.
5. Use the negative-pulsing
GRAY/VIOLET Auxiliary A output
to unlock the other doors (add a
relay for lock types that are not
negative-switching).
6. After power-up, set the Auxiliary A
output to 2-Stage Unlock (column 3,
row 3 in installer programming grid).
Parking Lights
1. Turn on the parking lights and access
the parking light wire:
n
Near the headlight switch
n
In the door sill harness going to the rear
lights
n
At any of the four parking light bulbs
2. If working underdash, turn the
dashlight dimmer to its lowest
setting.
3. Find the wire that shows +12V when
the parking lights are on and 0 volts
when off or, on most Japanese cars, 0
volts when on and +12V at rest.
4. Connect the BROWN wire to the parking light wire.
5. Connect the RED/WHITE and preconnected fuseholder to either:
a. +12V if the wire 12V in step 3 with the lights on.
b. Ground if the wire showed 0V in step 3 with the lights on.
Horn Connection
NOTE: If connecting a siren, refer to the Optional Siren section that follows.
1. Locate the wire that shows ground or +12V only when the horn is activated.
a. If ground, connect the YELLOW wire to the negative-switching car horn wire.
b. If +12V, use a relay to invert polarity.
Optional Dual-Zone Piezo Vibration/Impact Sensor
Mount the sensor in the passenger compartment, not in the engine compartment.
1. Firmly mount the sensor near the base of the steering column (if the steering column has a
rotating sleeve, firmly screw the sensor to the interior firewall, kick panel or trunk wall).
2. Mate the sensor to the connector with the ORANGE, BLUE, BLACK and RED wires.
3. After power-up, adjust sensitivity as noted in the instructions that come with the sensor.
5
+12V
RED/ORANGE
RED/GREEN
GRA
Y/ORANGE
WHITE/ORANGE WHITE/GREEN GRA
Y/GREEN
UNLOCK
LOCK
Wires coming in from door at kick panel
GRAY/ORANGE
RED/GREEN
WHITE/ORANGE
WHITE/GREEN
Wires coming in
from door at kick panel
RED/ORANGE
GRAY/GREEN
X
X
GRAY/GREEN
RED/GREEN
WHITE/GREEN
WHITE/ORANGE
RED/ORANGE
GRA
Y/ORANGE
not drawn to scale
Wire coming in from door at kick panel
X
cut
Door Switch
Compressor
Diagram 4:
Reverse Polarity
Diagram 5:
Adding Servos
Diagram 6: Vacuum Pump
+12V
+12V
+12V
+12V
7
D:...-922 Level 4 install manual.vp
Wed Aug 04 17:37:16 1999
Color profile: Disabled
Composite Default screen