Step 10: Test the optional Dual-Zone Piezo Sensor.
Arm, wait 10 seconds, then tap the car softly with your fist. The following should occur:
n
Horn beeps five times. This is the correct response.
Hit the car firmly with your fist. The following should occur:
n
Alarm triggers. Proceed to step 11.
If either of these test fail, adjust the sensor using the adjustment knob and retest. Keep in
mind that the sensor does not come online until about 10 seconds after arming.
Step 11: Test range and optional accessories.
Testing range and optional accessories, such as trunk release or the IntelliStart 4 remote
engine starting accessory, will require temporary addition of a Customer Care Kit remote
control. When testing is complete, reprogram the master remote control into the system. This
clears out the codes of any Customer Care Kit remote controls and returns the system to
Dealer Mode.
To test range, stand 30 feet from the vehicle and use the remote control to arm and disarm.
n
The system will respond as previously noted. If not:
§
Reposition the external receiver as high as possible under the dash and as far as possible from
heavy wirelooms and metal.
§
Reposition the antenna rod underdash or, for maximum range, run the antenna cable up the
window pillar and mount the antenna rod on the windshield about an inch below the roofline.
§
Make sure that the remote control battery measures at least 3 volts while transmitting.
§
Make sure the voltage at the control unit between the 5-amp fused power line and each the
ground line is at least 12.0 volts when triggered (if less, make sure the ground connection is solid;
if so, the vehicle battery may need charging, servicing or replacement).
§
Make sure no accessories are tapped in to the RED or BLACK power and ground wires.
13
15
D:...-922 Level 4 install manual.vp
Wed Aug 04 17:37:24 1999
Color profile: Disabled
Composite Default screen
