Unit 1, 10 Duerdin St, Clayton VIC 3168, Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
14
page
of 25
Installation Instruction
-Grounding Clips are intended for SINGLE USE
ONLY! Only fasten the bolts down when the
position of the PV Module is finalized. (Only slightly
tighten bolts to keep PV Modules in place prior to
the final check)
-Solution 2 (Apply Universal Clamps)
Step 1 Twisting the head of the Universal Clamp
changes the functionality from End to Inter Clamp as
shown in the figure on the right.
NOTE: Please ensure the Universal Clamp
C-U/30/46 or Universal Clamp with Grounding Clip
C-U/30/46-G is positioned correctly according to
5.3.1: Deployment of Grounding Clip.
Step 2 Incline the Universal Clamp to fit the lower
channel against the lower channel of the Rail, and
press the Universal Clamp down towards the other
side to securely fit the upper channel against the
upper rail channel, as shown in the figure on the righ
Note: Before installation, make sure there is enough
clearance between the screw and lower module of
Universal Clamp as shown in the figure on the right.
Step 3 Place the first PV Module on the Rails and
apply the Universal Clamp in the End Clamp
position and fasten slightly with the Allen Key. Make
sure the frame of the PV Module is fully in contact
with the Universal Clamp as shown in the figure on
the right. Visually check the Universal Clamp and PV
module are properly installed.
18mm
