Unit 1, 10 Duerdin St, Clayton VIC 3168, Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
13
page
of 25
Installation Instruction
5.3.3 Place the PV Modules on to the rails and
fix with End Clamps, Inter Clamps or Universal
Clamps. Fasten with the Allen key. Please
use Solution 1 or 2 below according to your
project.
-Solution 1 (Apply Standard Clamps)
-Step 1 Place the first PV Module on the Rail
according to your plan, and fix it in place
using the End Clamps. Then fasten lightly
with the Allen Key as shown in the figure on
the right.
-Step 2 Slightly lift the PV Module and slide
Inter Clamps and Grounding Clips into
position. The teeth on Grounding Clip will
automatically align when the Inter Clamp is
properly installed as shown in the figure on
the right.
-Step 3 loosely place the next framed PV
Module into the other side of the Inter Clamp
and Grounding Clip as shown in the figure on
the right.
Important Notes:
-To fix the Grounding Clip properly, ensure the
frames of PV Modules are completely pressed
against the Inter Clamps and Grounding
Clips. Visually check that Grounding Clips are
positioned properly.
OK
Not Good
