Installation – Local network
14
P2260JH | 2019-05
Apex Tool Group
6
EN
6
Installation – Local network
The following inputs are needed for the installation described below (example here Apex Tool Group stan-
dard settings):
Local network
Local network with switch
6.1
Setting up access point
The operating range of the wireless transmission can vary considerably depending on the installation loca-
tion of the access point. Note the following points when positioning:
•
Position the access point in the center of the tool being used.
•
Avoid any walls or corners of buildings between the access point and the tool. You will have the best
range if there is a clear line of sight between the access point and tool. If this cannot be realized, the
wall or ceiling should be penetrated at as acute an angle as possible to enable the signal to go directly
through the wall or ceiling.
•
Maintain a minimum clearance of 3 m to 6 m from devices that generate high-frequency interference,
such as microwaves.
1. Connect the access point to the service PX with an ethernet cable.
2. Connect the access point to the power supply.
3. Access point booting. Note indicator LEDs.
It is essential that national, state and local regulations and standards be followed.
Caution
Risk of injury due to electric shock.
Direct contact with mains voltage can cause injury due to electric shock.
Before exchanging components or supplementary equipment, isolate the power supply.
Device
Static IP address, e.g.
SSID
Subnet mask
Tool
192.168.0.1
LiveWire001
255.255.255.0
Controller
192.168.0.110
Access point
192.168.0.50
LiveWire001
Service PC
192.168.0.55
Device
Static
IP address, e.g.
SSID
Subnet mask
Tool 1
192.168.0.1
LiveWire001
255.255.255.0
Tool 2
192.168.0.2
LiveWire001
Controller 1
192.168.0.110
Controller 2
192.168.0.111
Access point 1
192.168.0.51
LiveWire001
Access point 2
192.168.0.52
LiveWire001
Service PC
192.168.0.55
