91b_1_5 en bedingt.fm, 24.09.2007
P1891E/EN 09/07
7
Safety
1
1.5
Designated use
The 47BA is designed exclusively for fastening and releasing threaded fasteners.
The communication with the controller TMEB-200 / TMEB-COM / TMEC is allowed only over the
following interface ports:
• Do not use it in areas where there is a risk of explosion.
• Do not open it or modify it structurally.
• Only use with accessory parts which are approved by the manufacturer
(see 3.3 System overview – optional accessories, page 16).
• Do not use as a hammer or for re-bending.
1.6
Codes and standards
It is mandatory that national, state and local codes and standards be followed.
1.6.1
FCC conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
1.6.2
Canada conformity
Operation is subject to the following two conditions: (1) this device may not cause harmful inter-
ference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
1.6.3
EMC
Industrial environment EMC limit class A.
The tool complies with the following EMC standards:
DIN EN 61000-6-4 Emitted interference
DIN EN 61000-6-2 Interference immunity
Types
Communications
All
IrDA interface port of the tool holder, order no. 935290
47BAW...
47BAX...
WLAN standard IEEE 802.11b
47BAR…
868 MHz with base station, order no. 961300 (EU)
47BAF…
915 MHz with base station, order no. 961301 (NA)
