91b_1_5 en bedingt.fm, 24.09.2007
P1891E/EN 09/07
13
Scope of supply, transport and storage
2
3.2.3
Start button
The start button has 3 functions (Standard for TMEB-200 / TMEC):
• It activates the LED lighting.
➔
Press the start button halfway down and hold it.
• It starts the motor, the LED light goes out.
➔
Press the start button all the way down.
• It activates the barcode scanner—only for types of the 47BA...S series.
➔
Press the start button all the way down.
3.2.4
Reverse switch
The reverse switch changes the rotation direction of the 47BA:
Clockwise rotation – for screwing in screws
Press reverse switch as far as it will go.
When the start button is pressed
Active
appears on the LCD display.
Counterclockwise rotation – for loosening or screwing out screws
Press reverse switch as far as it will go.
When the start button is pressed
Left
appears on the LCD display.
3.2.5
IrDA interface port
The 47BA communicates with the TMEB-200 / TMEC controller or a PC (TMEB-COM) via the
IrDA interface port. For secure data transmission and for programming the 47BA, place the 47BA
in the tool holder with IrDA interface port, Order no. 935290. Data transmission is possible in the
Active
,
Energy saver mode
and
Standby
operating modes, but not possible in
Sleep
(see 5.2 Operating status, page 19).
3.2.6
Identification – set torque
To identify the set torque on the 47BA, glue the corresponding marking foil to the right and the left
of the LCD display.
NOTE
If the data transmission has been interrupted, the 47BA reports
Synch error
on the LCD display.
Replace the 47BA in the tool holder. The complete data transmission is acknowledged on the
display with
Remain 512
.
Order No.
935759
Order No.
935330
