14
P1891E/EN 09/07
91b_1_5 en bedingt.fm, 24.09.2007
Scope of supply, transport and storage
2
3.2.7
LED lighting
LED lighting make it possible to quickly find the screw point.
3 different activation methods are possible. Define the method by programming
the TMEB-200 / TMEB-COM / TMEC correspondingly:
• Activation by pressing the start button halfway down (3.2.3 Start button, page 13).
• Time-controlled beginning at start
• You also have the option of disabling it.
The lighting distance is up to 4.7" (120 mm).
3.2.8
Rechargeable battery
For information on the battery, see
4.3 Charging the battery, page 17
4.4 Replacing the battery, page 18
10.4.1 Battery power supply, page 67.
3.2.9
LCD display
See 6 LCD display, page 21
3.2.10
Barcode scanner
For tools of the 47BA...S series, the built-in barcode scanner is a class 2 laser scanner with a
wavelength of 650 nm.
The barcode scanner reads one-dimensional linear barcodes:
Depending on how the TMEB-200 / TMEB-COM / TMEC is programmed, there are two different
operating modes:
Barcode as release for further rundowns
➔
Press the start button on the tool; this activates the barcode scanner.
The successful scan is acknowledged by an acoustic signal.
➔
Press the start button on the tool again; this starts the rundown.
If is necessary to read another barcode, proceed as follows.
CAUTION!
Eye injury from class 2 laser beam
➔
Do not look into the laser beam window when the laser is on.
➔
Repair any damage immediately.
Damage of the optical components can cause laser radiation.
➔
Modifications to the barcode scanner and procedures not outlined in these operating
instructions are strictly prohibited.
➔
Take defective devices out of operation immediately.
Scanning operation
Acoustic signal
• Successful
50 ms long
• Faulty
• Not within 3 seconds
•
Canceled
by pressing the start button
3 times in rapid succession
LASER RADIATION
DO NOT LOOK INTO THE BEAM
CLASS 2 LASER
IN ACCORDANCE WITH
EN 60825-1:1994
P < 1mW;
λ
= 630 nm
