Visit
www.ClearSpan.com
for additional products and customer assistance.
CLEARSPAN
™
POLY BUILDINGS
18
3. Wrap the Tek screw and joint using duct tape.
4. Repeat the steps and continue to assemble and feed
the PVC conduit into the pocket.
5. Once the PVC conduit is fully assembled, secured at
the joints, and inserted into the pocket, repeat the steps
for the remaining end of the main cover.
6. With both PVC conduits assembled and installed, verify
that the cover is centered on the frame and move to
one end rafter.
7. Cut four (4) sections of the 1" strap from the bulk roll
that are long enough to tie the PVC conduit to the end
rafter in evenly spaced locations.
INSTALL PVC CONDUIT (CONTINUED)
8. Move to the end of the frame opposite the end where
the temporary straps were tied.
9. Take one end of the bulk roll of 1" strapping and weave
it around the end rafter and PVC conduit.
10. Continue to weave the strap around the end rafter and
PVC conduit working up and over the rafter and down
to the other end of the PVC conduit.
NOTE:
Keep the strapping snug during this step, but
do not over tighten. Also, maintain a even distance
between the top of the end rafter and the PVC conduit.
Photo shows the installed strapping. Distance between
the conduit in the pocket and the end rafter is even.
11. After weaving the strapping, cut the strap and tie it to
the end rafter to temporarily secure it.
12. Take the remainder of the bulk strap roll, move to the
other end of the frame and repeat the steps to weave
the strap between the PVC conduit and the top of the
end rafter.
NOTE:
The temporary straps at this end (Step 7) can
be removed once the main strapping is in place.
13. After the strap is completely installed at this end, cut
the strap to length and tie it to the end rafter.
Dashed lines show the
temporary straps
(Step 7) tied between
the PVC conduit and
the top of the end rafter
to keep the main cover
centered on the frame
during the installation
of the strapping at the
other end of the frame.
End Rafter
PVC conduit in
notched pocket
Photo shows how
to weave strap
around the conduit
inside the main
cover pocket.
Cover shown
differs from actual
cover.
