CleanStation Dimension SRS-DT3
TM
Jet action cleaning
Rules for Safe Operation
Important: Do not attempt to operate the CleanStation
TM
until you have read thoroughly and understand all
instructions and safety rules contained in this manual. Failure to comply may result in personal injury.
•
As a normal industry safety practice, be sure the machine has been plugged into a 115VAC ground fault interrupt outlet.
• Protective neoprene gloves, as well as protective eye goggles should be worn when cleaning parts in the CleanStation
TM
.
Having a source of fresh water
nearby is helpful to wash off any solution that splashes on exposed skin or parts. During normal operation of the CleanStation, the tank and lid will
become hot (up to 150F). Care should be taken to avoid exposed skin touching these hot surfaces causing a burn.
• Use stainless steel or plastic tongs to insert and remove parts from the CleanStation
TM
tank.
DO NOT use aluminum tongs.
• Ambient lighting in the area where CleanStation
TM
is setup and used needs to be sufficient for the contents of the CleanStation to be seen with ease.
Artificial lighting that achieves an intensity of 200 to 300 Lux is usually sufficient.
• When the CleanStation
TM
is cleaning parts, it should
NOT
be left unattended.
• When operating the CleanStation
TM
, facing the front provides an unobstructed view of the control panel display, as well as direct access to the power
switch in case quick shutdown is necessary. All normal operations should be performed facing the front, with the exception of accessing the drain valve,
which is located on the back of the CleanStation
TM
.
• CleanStation
TM
weights approximately 63lb empty and should
NEVER
be moved when liquid is present in the tank. Sections 9 and 10 of the
Operations guide detail how to properly drain and dispose of used chemical solution prior to moving the CleanStation
TM
.
• CleanStation
TM
is designed for indoor use only, at room temperatures between 65F and 80F. CleanStation will not operate at a temperature at or below
40F.
• CleanStation
TM
is designed for cleaning with WaterWorks Soluble Concentrate (or other suitable substitute recommended by Stratasys, Inc. or PM
Technologies), to clean P400-ABS modeling and P400-SR support material. It is
NOT
designed for cleaning or heating food, cosmetic or medical
products, nor metal or other non-water soluble plastic parts. Do not use chemicals that are not pre-qualified by PM Technologies, this will result in
voiding the warranty.
• CleanStation
TM
should
NOT
be used in an explosive atmosphere. Normal internal sparking of the pump motor could ignite fumes.
• CleanStation
TM
has a working dimension inside the tank of 10 inch by 11 inch by 12-1/4” inch. Be careful not to insert too many parts (to be cleaned) so
as to overflow the level of the tank.
