CleanStation Dimension SRS-DT3
TM
Jet action cleaning
3. Connecting the drain
The CleanStation
TM
drain is located at the rear of the unit (see Figure 2). Install a standard 3/4” inside diameter hose to the 3/4”
barbed fitting attached to the drain valve.
4. To operate the system
Please review the previous section entitled "Rules for Safe Operation", then proceed to the next section "Operation".
Installation
1. Selecting a location
Select a clean, dry, well-lighted area with a minimum clearance of
six inches between the CleanStation
TM
and any adjacent walls. It is
especially important to select a level surface, due to liquid levels in
the tank.
The ideal room temperatures for the system are between 65F and
80F.
2. Power requirements
The CleanStation
TM
requires 115VAC, 60Hz, 15amp service.
As a
normal industry safety practice, a ground fault interrupt outlet
must be used.
drain valve
(shown shut)
Figure 2
