CleanStation Dimension SRS-DT3
TM
Jet action cleaning
9. Disposal of soluble solution
Method 1: Dilution
You may dispose of used solution by pouring it down the drain
while simultaneously
running tap water from the faucet. A 5-to-1
ratio (5 parts water to 1 part solution) is required to reduce the pH content to typical wastewater standards. Check local requirements
and modify this ratio accordingly.
Method 2: Neutralization
Malic acid may be used to neutralize the pH content of the solution. Using neoprene safety gloves and protective eye goggles, slowly
add 270 ml of malic acid to the tank before draining. Litmus paper (or an alternative pH indicator) may be used to determine if the
pH value of the solution is within local wastewater requirements. An alternative would be to drain the solution into a container big
enough to handle the full capacity of CleanStation
TM
. At that point mix in 270 ml of malic acid and dispose.
The Stratasys soluble solution is specially formulated to be safely disposed of by standard wastewater disposal procedures. PM
Technologies and Stratasys cannot anticipate local, state or international regulatory statutes. PM Technologies and Stratasys
recommend that disposal procedures be verified by the proper authorities in your region. PM Technologies and Stratasys cannot be
held liable if the solution is not disposed of properly.
10. Draining the tank
To drain the tank, check to make sure the power cord is unplugged and that a drain line is securely connected to the valve. Open the
drain valve until all of the water has emptied. Close the drain valve when not in use. If neutralizing with malic acid, a filmy residue
may remain in the tank which may be wiped off with paper towels.
Operation (continued)
