Front Hopper
[24]
9.8 Calibration Check
To ensure the metering unit has been calibrated correctly, it is possible to perform a
calibration check by observing the “Cal. Factor”. This is checked by firstly pressing the Setup
menu button, from the Setup menu the calibration check button should then be pressed
(Figure 27).
1.
Calibration check button
Figure 27 – Calibration check option
Once the calibration check button has been pressed the screen in Figure 28 will be
displayed and the “Cal. Fact” can now be seen. This value is the kg of seed dispensed for
each revolution of the metering unit.
Figure 28 – Calibration Factor highlighted
This value is generated after every calibration and can now be compared against the
calculated “Cal. Factors” in Appendix D (at the rear of the manual). If large discrepancies
are present between the “Cal. Factors” in Appendix D and what is displayed on the control
box, a recalibration may be required.
Содержание Hybrid Front Hopper
Страница 35: ...Front Hopper 33 Appendix B Declaration of Conformity ...
Страница 41: ...Front Hopper 39 ...
Страница 43: ...Front Hopper 41 Part s Manual ...
Страница 44: ...Front Hopper 42 Front Hopper Tank Assembly ...
