Clarke 7630073, Руководство по эксплуатации

Страница: 9 / 48

9
USING THE SHARP-ANGLE-BEND ATTACHMENT
PURPOSE OF THE ATTACHMENT
The sharp-angle-bend attachment is
used instead of the stop block when
you make a right-angle bend or
other sharp bend in flat material.
POSITIONING THE ATTACHMENT
In contrast to the stop block, the
sharp-angle bend attachment has
only one correct orientation—as
shown at right, and with the hinge pin
in the #2 hole in the loop.
POSITIONING THE BLOCK SUPPORT
The block support must be located under the sharp-angle-bend attachments,
to keep the attachment centered vertically in the loop. (Compare the
illustration on page 6 with the stop block.)
Install the support in the #3 loop hole,
so it will support the attachment but
not interfere with inserting the hitch
pin all the way through the
attachment’s hole and the lower
hole in the loop.
CLAMPING
The material should not need to be
clamped when using the sharp-
angle-bend attachment.
BENDING THE MATERIAL
Make thin chalk marks on the flat
material to show where you want to make the bends. For an example, see
page 10.
Insert the material into the bender so that half the width of the chalk mark
shows and the other half is covered by the bending edge of the attachment.
If you are making two right-angle bends on the same side of the material,
space their chalk marks about 1/8” further apart than the desired inside
dimension after the bend.