Clarke 7630073, Руководство по эксплуатации

Страница: 8 / 48

8
2. Install the appropriate die at the appropriate hole in the handle.
3. Inset a piece of the material to be formed. With the handle all the way
back (anticlockwise), install the stop block in the orientation that places it
as close to the centre pin as possible.
IMPORTANT: Always use the loop hole that places the stop block as close to
the centre pin or die as possible, while leaving space for the material to be
inserted.
If there is too much space between the stop block and the centre pin or die,
turn the block to a different orientation or move the block one hole closer to
the centre.
POSITIONING THE BLOCK SUPPORT
The block support must be located under the stop block as shown, to keep the
block centered vertically in the loop.
Install the support in the appropriate loop hole where it will support the stop
block but not interfere with inserting the hitch pin all the way through the
block hole and the lower hole in the loop.
CLAMPING
If the stop block is positioned
correctly, the material will normally
not have to be clamped in the
bender. However, when you are
making special bends or need
precise dimensions, it is helpful to
clamp the material against the stop
block using a vice-grip pliers as
shown at right.