Clarke 7630073, Руководство по эксплуатации

Страница: 21 / 48

21
BEND NO. 2
Slide the stock to the #2 chalk mark (as in B), and bend it to 76°. Re-check the
angle.
To remove the part from the Bender, remove the pin that holds the sharp-
angle-bend attachment.
FINISHING
Tack-weld the 3-1/2”. insert piece between the legs of the “A,” parallel to the
top edge. Grind and sand all sharp corners.
LETTER B
STOCK REQUIRED
• 3/16” stock; 2” max.
Width
SETUP
Make chalk marks on the
two 8-7/8” blanks as shown
on the “Bend Sequence.”
BEND NO. 1
Insert one of the blanks into the Bender to the #1 chalk mark (as in A), and
bend it to 45°. Re-check the angle before you go on to the second bend.
Chalk-mark the ring, or set a stop, for ease of repeating the 45° bend.
BEND NO. 2
Slide the stock to the #2 chalk mark (as in B), and bend it to 45°. Re-check the
angle.
BEND NO. 3
Reverse the stock end-for-end. Slide it to the #3 chalk mark (as in C), and bend
it to 45°. Re-check the angle.
BEND NO. 4
Again reverse the stock end-for-end. Move it to the #4 chalk mark (as in D),
and bend it to 45°. Re-check the angle.
To remove the part from the Bender, remove the pin that holds the sharp-
angle-bend attachment.