Clarke 7630073, Руководство по эксплуатации

Страница: 14 / 48

14
5. Make the first bend by pulling the
handle around until the handle die runs
off the end of the piece.
6. Reverse the part end-for-end. Insert it
into the Bender so that it extends 1-3/4”
beyond the centre-pin die (as in C).
7. Make the second bend by pulling the
handle around until the handle die runs
off the end of the piece.
8. Remove the stop block, and install the
sharp-angle-bend attachment.
9. You will have to temporarily remove the
centre pin to insert the piece into the
bender. Slide the piece as far left as
possible, against the centre pin (as in
D).
10. Make the third bend by pulling the
handle until it is about 1/8” from the
stop pin.
11. Reverse the part end-for-end. Slide the
piece as far left as possible, against the
centre pin (as in E). You will again have
to temporarily remove the centre pin to
insert the piece into the bender.
12. Make the fourth bend by pulling the
handle until it is about 1/8” from the
fixed stop.