Citizen CT-D150, Справочник по командам

Страница: 192 / 512

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
CT-D151/E651
- 191 -
FS S n1 n2
[Function] Setting Kanji space amount
[Code] <1C>H<53>H<n1><n2>
[Range] 0
≤n1≤255
0
≤n2≤255
[Outline] [The specification which is common to the model]
• Sets both right and left space amount of Kanji in units of dot.
• Sets left space amount by [n1×(Basic calculation pitch)] .
• Sets right space amount by [n2×(Basic calculation pitch)] .
[Caution] [The specification which is common to the model]
• The right and left space amount in double-width mode are twice the setting.
• Setting independent line feed amount is possible in STANDARD MODE and PAGE MODE.
• Basic calculation pitch is set by GS P. Even if basic calculation pitch is changed by GS P after setting space
amount, there is no change in the amount of line feed.
When fractional number is caused by the calculation, it is corrected by the minimum pitch of mechanism and
the rest is discarded.
• In STANDARD MODE, basic calculation pitch (x) in horizontal direction is used.
• In PAGE MODE, the following operation occurs depending on the start point.
(1) When the start point is set at “upper left” or “lower right” by ESC T, basic calculation pitch (y) of vertical
direction (paper feed direction) is used.
(2) When the start point is set at “upper right” or “lower left” by ESC T, basic calculation pitch (x) of horizontal
direction (at right angle to paper feed direction)is used.
• The maximum right spacing is capable of approximately 31.906 mm (255/203 inches). A setting greater than
this maximum is trimmed to the maximum.
[Default] n1=0, n2=0
[The specification which is common to the model]
CT-S801(II) / CT-S851(II) / CT-S601(II) / CT-S651(II) / CT-S310II / CT-S251 / CT-D150 / CT-E351 /
CT-D151 / CT-E651
When MSW6-2=OFF: n1=n2=0
When MSW6-1=ON: n1=0, n2=2