Citizen CT-D150, Справочник по командам

Страница: 511 / 512

- 510 -
5.4 Cautions on Black Mark/Label Paper
Cautions on LF (CR), ESC J, ESC d, Page mode, Image, and barcode printing.
Printing of image greater than vertical print area of BM paper/label paper used is prohibited as a rule.
The user must use label while taking label size into account at all times and terminate printing of a sheet of
label with FF, ESC FF or GS FF.
If printing of “E” of 2 times vertical (48 dots) is
attempted there, 48 dots are not printed in the
remaining area of 36 dots. Therefore, “E” is
printed from next label’s first print position.
Here, line feed of “E” must also be included in the
calculation of the height of “E”. (See figure below.)
AAAAAAAAAAAAAAAAAAA
BBBBBBBBBBBBBBBBB
CCCCCCCCCCCCCCCCC
DDDDDDDDDDDDDD
ＥＥＥＥＥＥＥＥＥＥ
After printing of “D” in the left figure, remainder of
vertical print area must be 36 dots.
AAAAAAAAAAAAAAAAAA
BBBBBBBBBBBBBBBB
CCCCCCCCCCCCCCCCC
EEEEEEEEEEEEEEEEEE
EEEEEEEEEEEEEEEEEE
60
ドット
Only character can be printed here but printed on
next label as feed amount cannot be applied.
As shown in the left figure, character height is 24
dots. If, however, line feed width is 60 dots by the
setting or command such as ESC 3 or the like,
vertical print area is calculated including line feed
width in character height. If printing in vertical area
is not available, printing is started from the first print
position of the next label.
The same principle applies to image and barcode.
Barcode and image are as shown on the next page.