Citizen CT-D150, Справочник по командам

Страница: 141 / 512

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
CT-D151/E651
- 140 -
GS a n
[Function] Enabling/disabling ASB (Automatic Status Back)
[Code] <1D>H<61>H<n>
[Range] 0
≤n≤255
[Outline] [The specification which is common to the model]
• This command selects the status item to be addressed by ASB (Automatic Status Back.)
Bit Status Item Addressed by ASB Hex. Decimal
0
Status of pin 3 of drawer kick-out connector = Disabled
00H 0
Status of pin 3 of drawer kick-out connector = Enabled
01H 1
1
Online/offline status = Disabled
00H 0
Online/offline status = Enabled
02H 2
2
Error status = Disabled
00H 0
Error status = Enabled
04H 4
3
Continuous Paper Sensor = Disabled
00H 0
Continuous Paper Sensor = Enabled
08H 8
4
Undefined
- -
5
Undefined
- -
6
Undefined
- -
7
Undefined
- -
[Caution] [The specification which is common to the model]
• If any status item is enabled, the status is sent to the host when this command is executed. After that time on,
the status is sent each time an enabled status item changes. Because each status item represents the
current condition, status items disabled for ASB may also have changed.
• The ASB function is disabled if all status items are disabled.
• If the ASB function is enabled by default, the host receives the status the first time the printer gets ready for
communication after it is turned on.
• The printer sends 4 bytes of status shown in the tables below, without checking whether the host is ready to
receive or busy. The 4 bytes of status is a continuous string except for XOFF code.
• Because this command is executed when data is mapped in the receive buffer, there may be a delay
between command receiving and status sending depending on the condition of the receive buffer.
• Even if the printer is excluded from the selection of peripheral equipment ESC =, the 4 bytes of status is sent
to the host whenever status changes.
• When DLE EOT, GS I, or GS r is used, the host must discriminate between the status specified by these
commands and the status due to ASB.