Citizen CT-D150, Справочник по командам

Страница: 229 / 512

Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
CT-D151/E651
- 228 -
CT-P29x series
• Setting MSW 1 (a=1)
n b (Set Value) Function
1
48 (Default) Reports the power on.
49 Does not report power on.
2
48 (Default) Sets input buffer capacity to 4K bytes.
49 Sets input buffer capacity to 45 bytes. (Note)
3
48 (Default) Sets input buffer full and offline to be Busy.
49 Sets to be busy with input buffer full.
4
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
49 At the occurrence of receiving error, ignores the data.
5
48 (Default) Disables CR (0DH).
49 Enables CR (0DH).
6 48 (Default) Reserved
7
48 (Default) Does not reset at serial I/F pin 6.
49 Resets at serial I/F pin 6.
8 48 (Default) Reserved
• Setting MSW 2 (a=2)
n b (Set Value) Function
1 49 (Default) Reserved
2
48 Disables auto cutter.
49(Default) Enables auto cutter.
3
48 (Default) Enables stored printing.
49 Disables stored printing.
4
48 (Default) Immediately after digit reaches full, line-feed is taken.
49 Immediately after digit reaches full, data wait is taken.
5
48 (Default) After head-down* and PE recovery, prints as it is.
49
After head-down* and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6
48 Sets paper width to 80 mm.
49 Sets paper width to 58(60) mm.
7 48 (Default) Reserved
8 48 Enables PNE.
49 (Default) Disables PNE.
• Setting MSW 3 (a=3)
n b (Set Value) Function
1
48 (Default) After clearing cutter error, can be restored by Feed SW.
49 After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default) Reserved
3
48 (Default) Resets with parallel pin 31.
49 Does not reset with parallel pin 31.
4
48 (Default) Uses thermal paper.
49 Uses Black mark paper.
5
48(Default) Used with 48 print columns
49 Used with 32 print columns.
6 48 (Default) Reserved
7
48 (Default) Sets EPSON compatible mode.
49 Sets CBM1000-compatible mode.
8
48 (Default)
Sets
platen-open
error during printing to be auto recovery
error.
49
Sets
platen-open
error during printing to be recoverable
error.