A-9
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Appendix A System Error Messages
Error Message and Recovery Procedures
with the CPE to achieve the link rate of the profile configured for the port.
When the reduced rate is achieved, link is dropped briefly, and the LRE and
CPE ports attempt to establish the profile link rate. If, after a time (typically
30 seconds), no LRE link is established, this message appears, and the port
LED is amber. The port continues to attempt to establish link, starting from the
reduced rate. This message could also mean that the switch or CPE is faulty.
Action
Change the profile on the port to one that has a lower rate or has a
longer reach. There might be too many impairments on the connection
between the switch and the CPE for the ports to sustain the profile rate. If you
suspect the switch or CPE is faulty, contact Cisco Systems.
Module Message
This section contains the Module error message.
MODULES-3-MAC_TBL_SIZE
Explanation
This messages means that dynamic module insertion supports less
MAC addresses.
Action
Reboot system to use the module.
Port Security Messages
This section contains the Port Security error message.
PORT_SECURITY-2-SECURITYREJECT
Explanation
This message means that a packet with an unexpected source
address is received on a secure port.
Action
Remove the station with the unexpected MAC address from the secure
port, or add the MAC address to the secure address table of the secure port.