R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
3-6
Cisco WRP500 Administration Guide
Chapter 3 Configure Voice Services
Register to the Service Provider
Register to the Service Provider
To use VoIP phone service, you must configure your WRP500 to the Internet Telephony Service Provider
(ITSP).
Note
Each line tab must be configured separately. Each line tab can be configured for a different ITSP.
Step 1
Log in as administrator.
Step 2
Under the
Voice
menu, click
Line 1
or
Line 2
to choose the line interface that you want to modify.
Step 3
In the
Proxy and Registration
section, enter the
Proxy
.
Step 4
In the
Subscriber Information
section, enter the
User ID
and
Password
.
Note
These are the minimum settings for most ITSP connections. Enter the account information as
required by your ITSP.
Step 5
Click
Submit
. The devices reboot.
Step 6
To verify your progress, perform the following tasks:
•
Under the
Voice
menu, click
Info
. Scroll down to the
Line 1 Status
or
Line 2 Status
section of the
page, depending on which line you configured. Verify that the line is registered. Refer to the
following example.
•
Use an external phone to place an inbound call to the telephone number that was assigned by your
ITSP. Assuming that you have left the default settings in place, the phone should ring and you can
pick up the phone to get two-way audio.
IMAGE WILL BE SUPPLIED (SCREENSHOT) - replaces 194553
IMAGE WILL BE SUPPLIED (SCREENSHOT) - replaces 194554
