Cisco WAE-674-K9 - Wide Area Application Engine 674, Руководство по установке оборудования

Страница: 58 / 152

Chapter 4 Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
Replacing a Hard Disk Drive
4-14
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
OL-15012-02
Figure 4-9 Replacing a Hard Disk Drive
Tray handle
Hard disk drive
185094
Step 5
Pull the hot-swap drive assembly from the bay.
Step 6
Wait for 1 minute and then insert the new drive into the same slot by aligning the
replacement drive assembly with guide rails in the bay and sliding the drive
assembly into the bay until it stops. Make sure that the drive is properly seated in
the bay.
Note
Be sure there is no data on the replacement drive. The replacement hard
drive should be new or newly-formatted.
Step 7
Close the drive handle.
Step 8
Check the hard disk drive status LED to verify that the hard disk drive is operating
correctly. If the amber hard disk drive status LED for a drive is lit continuously,
that drive is faulty and must be replaced. If the green hard disk drive activity LED
is flashing, the drive is being accessed.
Step 9
Wait 1 minute and then verify that the replaced disk drive is in the Rebuilding state
by using the
show disks details command in EXEC mode.
Note The ServeRAID controller automatically starts the rebuild operation
when it detects the removal and reinsertion of a drive that is part of the
logical RAID drive.