Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
162
7
To get better detection by the IVR, avoid inband and use OOB. This way, the DTMF
tone is reconstructed by the PSTN gateway or the remote endpoint, and the
quality is not subject to distortion from the audio codec. If you use OOB, use a
slightly longer DTMF Playback Length.
If you use inband, use a higher Inband DTMF boost.
Localizing Your IP Phone
The following table describes the localization parameters in the
Miscellaneous
section.
Field
Description
Set Local Date
(mm/dd)
Enter the local date (
mm
represents the month and
dd
represents
the day). The year is optional and uses two or four digits. For
example,
May 1, 2008, can be entered as:
05/01 or 05/01/08 or 05/01/2008
Set Local Time
(HH/mm)
Enter the local time (
hh
represents hours and
mm
represents
minutes). Seconds are optional.
Time Zone
Selects the number of hours to add to GMT to generate the local
time for caller ID generation. Choices are GMT-12:00, GMT-
11:00,…, GMT, GMT+01:00, GMT+02:00, …, GMT+13:00.
Defaults to GMT-08:00.
Time Offset (HH/
mm)
This specifies the offset from GMT to use for the local system
time.
Daylight Saving
Time Rule
Enter the rule for calculating daylight saving time. See the
“Configuring Daylight Savings Time” section on page 164
.
Daylight Saving
Enable
Select yes to enable or no to disable DST on the phone. This
setting affects all lines (extensions) on the phone.
Dictionary Server
Script
Defines the location of the dictionary server, the languages
available and the associated dictionary. See the
“Creating a
Dictionary Server Script” section on page 167
.
