Configuring Security, Quality, and Network Features
Configuring VLAN Settings
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
127
5
STEP 5
Click Submit All Changes.
Configuring VLAN Settings
Using the IP Phones in a VLAN
If you use a VLAN your IP phone voice packets are tagged with the VLAN ID. (This
section is not applicable to the WIP310.)
If you are using a Cisco switch, Cisco discovery protocol (CDP) is enabled (this is
the default). CDP is negotiation-based and determines which VLAN the IP phone
resides in. CDP:
Syslog Server
Specify the syslog server name and port. This feature
specifies the server for logging system information and
critical events. If both Debug Server and Syslog Server
are specified, Syslog messages are also logged to the
Debug Server.
Debug Server
The debug server name and port. This feature
specifies the server for logging debug information. The
level of detailed output depends on the debug level
parameter setting.
Debug Level
The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
NTP Enable
Enables Network Time Protocol (NTP).
Applies to the SPA 525G only.
Primary NTP Server
IP address or name of primary NTP server. The phones
use these servers to synchronize its time. Defaults to
blank.
Secondary NTP Server
IP address or name of secondary NTP server. The
phones use these servers to synchronize its time.
Defaults to blank.
Parameter
Description