Cisco RV260 series, Руководство администратора

Страница: 121 / 124

For IPv6 traffic, the DSCP matches the traffic class value in the IPv6 header and places
it in different queues. The traffic class value is 4 times the DSCP value. For example, if
the user configures the DSCP as 10 mapping to Queue 1, then the IPv6 flows with traffic
class value 40 are put into Queue 1. The switch must use the DSCP field of the incoming
packets and schedule the packet for prioritization into a particular queue using the mapping
table.
• Based on the DSCP value of the incoming packet, select a queue from the drop-down
list to map the traffic.
DSCP-based
The switch uses the incoming packet priority class of service (CoS); bits and classifies
the packet to the user configured queue.
• Based on the CoS value of the incoming packet, select a queue from the drop-down
list to map the traffic.
CoS-based
Step 2 Click
Apply
.
Switch Queuing
In Switch Queuing, the queue weight for the four queues per port, can be configured by assigning weights to
each queue. The range of weights can be from 1 to 100.
When LAG is enabled, you can define the queue weights for each of the four queues.
If the weight is 0, the queue is in the highest priority queue.
Note
To configure Switch Queuing, click
QoS > Switch Queuing
and complete the following steps:
Step 1
In Switch Queuing, select the appropriate weight for each of the queues.
Step 2 Click
Apply
.
Step 3 Click Restore Defaults to restore system default settings.
RV260x Administration Guide
113
QoS
Switch Queuing