Cisco RV260 series, Руководство администратора

Страница: 120 / 124

Step 7 Click Apply .
WAN Bandwidth Management
The WAN interfaces can be configured with the maximum bandwidth provided by the ISP. When the value
(transfer rate in KBP/S) is configured, the traffic entering the interface is shaped in defined rate.
To configure the WAN Bandwidth Management, follow these steps:
Step 1
Click QoS > WAN Bandwidth Management .
Step 2 In the WAN Bandwidth Management table, select the interface and configure the following:
Enter the upstream traffic rate in kb/s. Upstream (kb/s)
Enter the downstream traffic rate in kb/s. *You will need to enable WAN policing for
Downstream Bandwidth, otherwise the downstream bandwidth will not take effect.
Downstream (kb/s)
Select the outbound queuing policy to be applied to the WAN interface. Outbound Queuing Policy
Select the inbound policing from the drop-down list. Inbound Policing
Step 3 Click Apply .
Switch Classification
In QoS modes such as Port-based, DSCP-based, and CoS-based, the packets are sent out.
To configure QoS Switch Classification, click QoS > Switch Classification and follow these steps:
Step 1
Select the desired Switch QoS Mode ( Port-based, DSCP-based, or CoS-based ).
The incoming packets on each LAN port which are mapped to specific queues, based
on the mappings.
• Queue - Select the queue to map the traffic coming on the individual LAN ports.
• Link Aggregate Group (LAG) Port Queue - When LAG is enabled, all traffic
entering this LAG interface is mapped using a configured queue.
Port-based
RV260x Administration Guide
112
QoS
WAN Bandwidth Management