Cisco Prisma II, Инструкция по установке и эксплуатации

Страница: 46 / 146

Chapter 2 Module Installation
22 78-4015908-01 Rev F
To Install the Module in the Chassis
Note: This procedure assumes that the chassis is mounted in a rack.
1 Locate the fiber guides at the bottom of the chassis and the module guide slots
inside the chassis as shown in the following illustration.
2 Align the ridges on the top and bottom of the host module with the guide slots
on the chassis. Be careful to keep the host module level as you slide it into the
chassis to avoid bending the pins on the back plane bus.
3 Gently slide the host module into the chassis until you feel the connections on
the back of the host module join connectors on the back plane bus.
Note: Do not force or bang the host module into the chassis. If properly aligned,
the host module should slide in with minimal force.