Cisco NAC-3310, Руководство по установке

Страница: 36 / 176

1-22
Cisco NAC Appliance Hardware Installation Guide
OL-20326-01
Chapter 1 Cisco NAC Appliance Hardware Platforms
NAC-3310, NAC-3350, and NAC-3390
Figure 1-21 Cisco NAC-3350 Front Panel LEDs/Buttons
1
Hard drive bay 1
4
Video connector
2
Hard drive bay 2
5
HP Systems Insight Display
3
CD-ROM/DVD drive
6
USB connector
1
Power On/Standby button
and system power LED Green = System is on
Amber = System is shut down, but power is still applied
Off = Power cord is not attached, power supply failure has
occurred, no power supplies are installed; facility power is not
available, or disconnected power button cable
2
UID button/LED Blue = Identification is activated
Flashing blue = System is being managed remotely
Off = Identification is deactivated
3
Internal health LED Green = System health is normal
Amber = System health is degraded. (To identify the component in
a degraded state, refer to “HP Systems Insight Display and LEDs.”)
Red = System health is critical. (To identify the component in a
critical state, refer to “HP Systems Insight Display and LEDs.”)
Off = System health is normal when in standby mode
4
External health LED
(power supply) Green = Power supply health is normal
Amber = Power redundancy failure occurred
Off = Power supply health is normal when in standby mode
5
NIC 1 (eth0) link/activity
LED Green = Network link exists
Flashing green = Network link and activity exist
Off = No link to network exists
If power is off, the front panel LED is not active. For status, view
the rear panel LED for the RJ-45 connector (
Figure 1-23 on
page 1-23 ).
6
NIC 2 (eth1) link/activity
LED Green = Network link exists
Flashing green = Network link and activity exist
Off = No link to network exists
If power is off, the front panel LED is not active. For status, view
the rear panel LED for the RJ-45 connector (
Figure 1-23 on
page 1-23 ).
1 2 3
4
5
6
180960