Cisco NAC-3310, Руководство по установке

Страница: 113 / 176

3-43
Cisco NAC Appliance Hardware Installation Guide
OL-20326-01
Chapter 3 Installing the Clean Access Manager and Clean Access Server
Useful CLI Commands for the CAM/CAS
Restart Initial Configuration
To start the configuration script, type
service perfigo config
while connected through SSH. For
example:
[root@camanager root]# service perfigo config
This command causes the configuration utility script to start (on either the CAS or CAM). The script lets
you configure the network settings for the CAM (see
Perform the Initial CAM Configuration, page 3-6
for instructions). After running and completing
service perfigo config
, make sure to run
service
perfigo reboot
or
reboot
to reset the CAM with the modified configuration settings.
Note
For details on restoring the database from automated and manual backup snapshots via command line
utility, see the
Cisco NAC Appliance - Clean Access Manager Configuration Guide, Release 4.8(3) .
CAS CLI Commands
The CAM web admin console allows you to perform most of the tasks required for administering Cisco
NAC Appliance deployment. However, there are two cases where the command line interface of the
CAS can be or must be used:
•
Use the CAS CLI Commands for Cisco NAC Appliance to access the CAS configuration directly
for initial configuration of the CAS or if the web admin console is unavailable due to incorrect
network or VLAN settings.
• If you have purchased the Cisco NAC Profiler solution, use the CAS CLI Commands for Cisco NAC
Profiler to enable the Cisco NAC Profiler Collector application on the Clean Access Server.
To run the CLI commands, access the CAS using SSH and log in as user
root
and enter the root user
password. If already serially connected to the CAS, you can run CLI commands from the terminal
emulation console after logging in as
root
(see Connect the Clean Access Manager, page 3-4 ).
CAS CLI Commands for Cisco NAC Appliance
The format
service perfigo <command>
is used to enter a command from the command line. Table 3-3
lists the commonly used Cisco NAC Appliance CLI commands.
Table 3-4 Cisco NAC Appliance CLI Commands for CAS
Command Description
service perfigo start
Starts up the CAS. If the CAS is already running, a warning message
appears. The CAS must be stopped for this command to be used.
service perfigo stop
Shuts down the Cisco NAC Appliance service.
Note When the management VLAN is set, this command will cause
the CAS to lose network connectivity when issued. You can
use
service perfigo maintenance
instead.