Cisco NAC-3310, Руководство по установке

Страница: 110 / 176

3-40
Cisco NAC Appliance Hardware Installation Guide
OL-20326-01
Chapter 3 Installing the Clean Access Manager and Clean Access Server
Serial Connection to the CAM and CAS
Step 6
Configure the Port Settings as follows:
• Bits per second – 9600
•
Data bits – 8
• Parity – None
•
Stop bits – 1
• Flow control – None
Step 7
Go to File > Properties to open the Properties dialog for the session and change the Emulation setting
to
VT100
.
Step 8 You should now be able to access the command interface for the CAM or CAS. You can now:
•
Install the Clean Access Manager (CAM) Software from CD-ROM, page 3-5
• Install the Clean Access Server (CAS) Software from CD-ROM, page 3-22
•
Perform the Initial CAM Configuration, page 3-6
• Perform the Initial CAS Configuration, page 3-24
Note If you already performed the initial installation, but need to modify the original settings, you can log in
as user
root
and run the
service perfigo config
command.
Configuring Boot Settings on the Cisco NAC Appliance CAM/CAS
If your CAM or CAS does not read the software on the CD-ROM drive, and instead attempts to boot
from the hard disk, use the following steps to configure the appliance to boot from CD-ROM before
attempting to re-image or upgrade the appliance from CD.
Step 1 Press the F10 key while the system is booting.
Step 2
Go to the Boot menu ( Figure 3-11 ).