Cisco HSI 4.1, Руководство пользователя

Страница: 78 / 199

4-6
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 4 Managing the Cisco HSI
Overload
Resetting Measurements
The clr-meas MML command resets the measurement counters. This command resets an individual
counter or all counters in a counter group. The following are valid counter groups:
• RAS
•
Q.931
• H.245
For more information about the clr-meas command, see Appendix A, “MML User Interface and
Command Reference.”
Retrieving Counters
Use the rtrv-ctr MML command to retrieve measurement counters. This command displays the
measurements for a counter group. Valid counter groups are RAS, Q.931, and H.245. For more
information about the
rtrv-ctr command, see Appendix A, “MML User Interface and Command
Reference.”
Overload
The system continuously checks call totals and CPU utilization. Each of these values is compared to
predefined limits. Three call total limits are available. Each limit has a hysteresis value and an alarm
associated with it. When the call total reaches the limit, an alarm is raised. When the call total falls below
the limit minus the hysteresis value, the alarm is cleared after the appropriate recovery action is taken.
Cisco HSI supports the following three levels of overload:
• Overload level 1
•
Overload level 2
• Overload level 3
The following factors can trigger any one of the overload levels:
•
CPU usage (the OVLDSAMPLERATE parameter defines the frequency of CPU sampling and threshold
checking)
•
Maximum calls allowed
ASYMMETRIC_TOT H245
Integer
Incremented for each asymmetric
condition encountered. Collection
intervals are provisionable (default is 12
hours).
DTMF_ RELAY_ TOT H245
Integer
Incremented for each call where DTMF
relay is used. Collection intervals are
provisionable (default is 12 hours).
Table 4-3 H.245 Counter Group (continued)
Counter Name Measurement Type Comments