Cisco Catalyst 3650 Series, Справочник по командам

Страница: 324 / 1108

debug lacp
To enable debugging of Link Aggregation Control Protocol (LACP) activity, use the debug lacp command
in privileged EXEC mode. To disable LACP debugging, use the no form of this command.
debug lacp [ all | event | fsm | misc | packet ]
no debug lacp [ all | event | fsm | misc | packet ]
Syntax Description
(Optional) Displays all LACP debug messages. all
(Optional) Displays LACP event debug messages. event
(Optional) Displays messages about changes within the LACP finite state machine. fsm
(Optional) Displays miscellaneous LACP debug messages. misc
(Optional) Displays the receiving and transmitting LACP control packets. packet
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
The undebug etherchannel command is the same as the no debug etherchannel command.
When you enable debugging on a stack, it is enabled only on the active switch. To enable debugging on the
standby switch , start a session from the active switch by using the
session switch-number command in
privileged EXEC mode. Enter the
debug
command at the command-line prompt of the standby switch.
To enable debugging on the standby switch without first starting a session on the active switch, use the remote
command switch-number LINE command in privileged EXEC mode.
Examples This example shows how to display all LACP debug messages:
Device# debug LACP all
This example shows how to display debug messages related to LACP events:
Device#
debug LACP event
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
298
debug lacp