Cisco Catalyst 3650 Series, Справочник по командам

Страница: 63 / 1108

Enables error detection on an SFP configuration mismatch. sfp-config-mismatch
Command Default
Detection is enabled for all causes. All causes, except per-VLAN error disabling, are configured to shut down
the entire port.
Command Modes
Global configuration
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SE
Usage Guidelines
A cause (such as a link-flap or dhcp-rate-limit) is the reason for the error-disabled state. When a cause is
detected on an interface, the interface is placed in an error-disabled state, an operational state that is similar
to a link-down state.
When a port is error-disabled, it is effectively shut down, and no traffic is sent or received on the port. For
the bridge protocol data unit (BPDU) guard, voice-aware 802.1x security, and port-security features, you can
configure the switch to shut down only the offending VLAN on the port when a violation occurs, instead of
shutting down the entire port.
If you set a recovery mechanism for the cause by entering the errdisable recovery global configuration
command, the interface is brought out of the error-disabled state and allowed to retry the operation when all
causes have timed out. If you do not set a recovery mechanism, you must enter the
shutdown and then the
no shutdown commands to manually recover an interface from the error-disabled state.
To verify your settings, enter the
show errdisable detect
privileged EXEC command.
Examples This example shows how to enable error-disabled detection for the link-flap error-disabled cause:
Device(config)# errdisable detect cause link-flap
This command shows how to globally configure BPDU guard for a per-VLAN error-disabled state:
Device(config)#
errdisable detect cause bpduguard shutdown vlan
This command shows how to globally configure voice-aware 802.1x security for a per-VLAN error-disabled
state:
Device(config)# errdisable detect cause security-violation shutdown vlan
You can verify your setting by entering the
show errdisable detect
privileged EXEC command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
37
errdisable detect cause