Configuring Subscriber Session Tracing
▀ Introduction
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
212
Introduction
The Subscriber Level Trace provides a 3GPP standards-based session-level trace function for call debugging and testing
new functions and access terminals in an LTE environment.
In general, the Session Trace capability records and forwards all control activity for the monitored subscriber on the
monitored interfaces. This is typically all the signaling and authentication/subscriber services messages that flow when a
UE connects to the access network.
The EPC network entities like MME, S-GW, P-GW support 3GPP standards based session level trace capabilities to
monitor all call control events on the respective monitored interfaces including S6a, S1-MME and S11 on MME, S5,
S8, S11 at S-GW and S5 and S8 on P-GW. The trace can be initiated using multiple methods:
Management initiation via direct CLI configuration
Management initiation at HSS with trace activation via authentication response messages over S6a reference
interface
Signaling based activation through signaling from subscriber access terminal
Important:
Once the trace is provisioned it can be provisioned through the access cloud via various signaling
interfaces.
The session level trace function consists of trace activation followed by triggers. The time between the two events is
where the EPC network element buffers the trace activation instructions for the provisioned subscriber in memory using
camp-on monitoring. Trace files for active calls are buffered as XML files using non-volatile memory on the local dual
redundant hard drives on the chassis. The Trace Depth defines the granularity of data to be traced. Six levels are defined
including Maximum, Minimum and Medium with ability to configure additional levels based on vendor extensions.
Important:
Only Maximum Trace Depth is supported in the current release.
The following figure shows a high-level overview of the session-trace functionality and deployment scenario:
