PDN Gateway Configuration
▀ Configuring the System as a Standalone eGTP P-GW
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
114
Step 1
Set system configuration parameters such as activating PSCs by applying the example configurations found in the
System Administration Guide
.
Step 2
Set initial configuration parameters such as creating contexts and services by applying the example configurations
found in the
Initial Configuration
section of this chapter.
Step 3
Configure the system to perform as an eGTP P-GW and set basic P-GW parameters such as eGTP interfaces and IP
routes by applying the example configurations presented in the
P-GW Service Configuration
section.
Step 4
Configure the PDN context by applying the example configuration in the
P-GW PDN Context Configuration
section.
Step 5
Enable and configure the active charging service for Gx interface support by applying the example configuration in the
Active Charging Service Configuration
section.
Step 6
Create a AAA context and configure parameters for policy by applying the example configuration in the
Policy
Configuration
section.
Step 7
Verify and save the configuration by following the steps found in the
Verifying and Saving the Configuration
section.
Initial Configuration
Step 1
Set local system management parameters by applying the example configuration in the
Modifying the Local Context
section.
Step 2
Create the context where the eGTP service will reside by applying the example configuration in the
Creating and
Configuring an eGTP P-GW Context
section.
