Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 859 / 1154

2-829
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
switchport access
These restrictions apply to dynamic-access ports:
• The software implements the VLAN Query Protocol (VQP) client, which can query a VMPS such
as a Catalyst 6000 series switch. The Catalyst 3750 switches are not VMPS servers. The VMPS
server must be configured before a port is configured as dynamic.
•
Use dynamic-access ports only to connect end stations. Connecting them to switches or routers (that
use bridging protocols) can cause a loss of connectivity.
• Configure the network so that STP does not put the dynamic-access port into an STP blocking state.
The Port Fast feature is automatically enabled on dynamic-access ports.
•
Dynamic-access ports can only be in one VLAN and do not use VLAN tagging.
• Dynamic-access ports cannot be configured as
–
Members of an EtherChannel port group (dynamic-access ports cannot be grouped with any
other port, including other dynamic ports).
– Source or destination ports in a static address entry.
–
Monitor ports.
Examples This example shows how to change a switched port interface that is operating in access mode to operate
in VLAN 2 instead of the default VLAN:
Switch(config-if)# switchport access vlan 2
You can verify your setting by entering the show interfaces interface-id switchport privileged EXEC
command and examining information in the Administrative Mode and Operational Mode rows.
Related Commands Command Description
show interfaces switchport Displays the administrative and operational status of a switching
(nonrouting) port, including port blocking and port protection settings.
switchport mode Configures the VLAN membership mode of a port.