Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 27 / 1154

1-3
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 1 Using the Command-Line Interface
CLI Command Modes
User EXEC Mode
After you access the device, you are automatically in user EXEC command mode. The EXEC commands
available at the user level are a subset of those available at the privileged level. In general, use the user
EXEC commands to temporarily change terminal settings, perform basic tests, and list system
information.
The supported commands can vary depending on the version of software in use. To display a
comprehensive list of commands, enter a question mark (
? ) at the prompt.
Switch> ?
Privileged EXEC Mode
Because many of the privileged commands configure operating parameters, privileged access should be
password-protected to prevent unauthorized use. The privileged command set includes those commands
contained in user EXEC mode, as well as the
configure privileged EXEC command through which you
access the remaining command modes.
If your system administrator has set a password, you are prompted to enter it before being granted access
to privileged EXEC mode. The password does not appear on the screen and is case sensitive.
The privileged EXEC mode prompt is the device name followed by the pound sign (
#
).
Switch#
Enter the enable command to access privileged EXEC mode:
Switch> enable
Switch#
The supported commands can vary depending on the version of software in use. To display a
comprehensive list of commands, enter a question mark (
? ) at the prompt.
Switch# ?
To return to user EXEC mode, enter the disable privileged EXEC command.
Config-vlan In global configuration mode,
enter the
vlan vlan-id command.
Switch(config-vlan)#
To exit to global configuration mode,
enter the
exit command.
To return to privileged EXEC mode,
enter the
end command, or press
Ctrl-Z .
VLAN
configuration From privileged EXEC mode,
enter the
vlan database
command.
Switch(vlan)# To exit to privileged EXEC mode,
enter the
exit command.
Line configuration From global configuration mode,
specify a line by entering the
line
command.
Switch(config-line)#
To exit to global configuration mode,
enter the
exit command.
To return to privileged EXEC mode,
enter the
end command, or press
Ctrl-Z .
Table 1-1 Command Modes Summary (continued)
Command Mode Access Method Prompt Exit or Access Next Mode