Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 1014 / 1154

B-42
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform dot1x
debug platform dot1x
Use the debug platform dot1x privileged EXEC command to enable debugging of stack-related
IEEE 802.1x events. Use the no form of this command to disable debugging.
debug platform dot1x { initialization | interface-configuration | rpc }
no debug platform dot1x { initialization | interface-configuration | rpc }
Syntax Description
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the
session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
initialization Display IEEE 802.1x-authentication initialization sequence debug
messages.
interface-configuration Display IEEE 802.1x interface configuration-related debug messages.
rpc Display IEEE 802.1x remote procedure call (RPC) request debug
messages.
Release Modification
12.1(11)AX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.