B-21
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Working with Configuration Files
generated. The resulting differences are used to replace the configuration. The configuration
replacement operation is usually completed in no more than three passes. To prevent looping behavior
no more than five passes are performed.
You can use the
copy
source-url
running-config
privileged EXEC
command to copy a stored
configuration file to the running configuration. When using this command as an alternative to the
configure replace
target-url
privileged EXEC command, note these major differences:
•
The
copy
source-url
running-config
command is a merge operation and preserves all the commands
from both the source file and the running configuration. This command does not remove commands
from the running configuration that are not present in the source file. In contrast, the
configure
replace
target-url
command removes commands from the running configuration that are not present
in the replacement file and adds commands to the running configuration that are not present.
•
You can use a partial configuration file as the source file for the
copy
source-url
running-config
command. You must use a complete configuration file as the replacement file for the
configure
replace
target-url
command.
Rolling Back a Configuration
You can also use the
configure replace
command to roll back changes that were made since the previous
configuration was saved. Instead of basing the rollback operation on a specific set of changes that were
applied, the configuration rollback capability reverts to a specific configuration based on a saved
configuration file.
If you want the configuration rollback capability, you must first save the running configuration before
making any configuration changes. Then, after entering configuration changes, you can use that saved
configuration file to roll back the changes by using the
configure replace
target-url
command.
You can specify any saved configuration file as the rollback configuration. You are not limited to a fixed
number of rollbacks, as is the case in some rollback models.
Configuration Guidelines
Follow these guidelines when configuring and performing configuration replacement and rollback:
•
Make sure that the switch has free memory larger than the combined size of the two configuration
files (the running configuration and the saved replacement configuration). Otherwise, the
configuration replacement operation fails.
•
Make sure that the switch also has sufficient free memory to execute the configuration replacement
or rollback configuration commands.
•
Certain configuration commands, such as those pertaining to physical components of a networking
device (for example, physical interfaces), cannot be added or removed from the running
configuration.
–
A configuration replacement operation cannot remove the
interface
interface-id
command line
from the running configuration if that interface is physically present on the device.
–
The
interface
interface-id
command line cannot be added to the running configuration if no
such interface is physically present on the device.
•
When using the
configure replace
command, you must specify a saved configuration as the
replacement configuration file for the running configuration. The replacement file must be a
complete configuration generated by a Cisco IOS device (for example, a configuration generated by
the
copy running-config
destination-url
command).
