OG_MU2-ESP_v10e
28
Circuit Design, Inc.
OPERATION GUIDE
[1] Save graph as image file (Ctrl+G)
Saves the measurement results as Windows extended metafiles (EMF), metafiles (WMF), bitmaps (BMP) and
JPEG (JPG).
[2] Image viewer (Ctrl+I)
Starts up the image viewer.
[3] Copy to the clipboard (Ctrl+C)
Copies the graph to the clipboard as image data. Specify the format of copied images in the Option dialogue. You
can copy in the EMF, WMF, and BMP formats.
[4] Print graph (Ctrl+P)
Prints the measurement results. The range printed is the area of the graph.
[5], [6], [7] Zoom out (F10), Zoom in (F11), Undo zoom (F12)
[8] Show the center line (F7)
Selects whether to show the center line.
[9] Show analyse line (F8)
Selects whether to show the analyse line.
[11], [18], [19] Bar style
Changes the style of the progress bar.
LED: Shows the progress bar as LEDs. (F5)
Point: Shows the progress bar as points. (F6)
[12], [16], [17] Graph view
Changes the appearance of the graph.
3D: Shows the graph in 3D. (F3)
Normal: Shows the graph normally (2D). (F4)
[13] Load graph data (Ctrl+L)
Loads saved graph data. Do NOT load files with a file extension other than ‘.AMF' or ‘.AMT’.
[14] Save graph data (Ctrl+S)
Saves graph data as a file. Do not change the file extension.
The file extension is ‘.AMF' for the frequency domain mode, and ‘.AMT’ for the time domain mode.
[15] Option (Ctrl+O)
Shows the Option dialogue.
■
2.4.4 Cautions when using the air monitor
◆
The air monitor function operates with the Equipment ID EI = FFh.
When using the control and test window or communication test functions, always check the Equipment ID and
so on again. Communication is not possible if the Destination ID and Equipment ID do not match. In addition,
check the channel again.
◆
Do not change to the control and test window or communication test window during measurement with the air
monitor. Doing so changes the Equipment ID and channel number. In this case, reset the ID and channel.
When finishing on the air monitoring function screen, the Equipment ID will be ‘FFh’ unless the power of the
MU-2-R is turned off. In addition, the channel number stays
same when the function finishes. Check them
before using the equipment again.
Note
