OG_MU2-ESP_v10e
15
Circuit Design, Inc.
OPERATION GUIDE
■
2.2.10 Command issue panel
On this panel it is possible to check and set the internal settings of the various parameters. To set the parameters,
attach the setting parameter to the command displayed in the data input line 2 and press the transmission button.
7
5
8
6
9
10
13
11
12
3
4
2
1
[1] Button for switching to the command issue panel
[2] Button for switching to the packet success rate test panel
[3] Button for switching to the setting value acquisition panel
[4] Button for switching to the other functions panel
[5] Other
[6] Mode
[7] Link parameter
You can issue the communication link related commands and check the internal states. Pressing the “Get link
parameter” button acquires multiple parameters. Pressing the “Link parameter Ini.” button initializes the link
parameters on the work memory. The content of the EEPROM will be retained.
[8] Serial parameter
You can issue the serial communication related commands and check the internal states.
[9] Issue RSSI related parameter
You can issue the RSSI related commands and check the parameters.
[10] Reset the source station [11] Reset the target station
Resets the source station and target station to the same status as when the power is turned on.
[12] Initialize the source station
Clicking this button returns the source station to the factory default values. Note that the content of the EEPROM
is also rewritten.
[13] Help
Help for the command issue panel.
