OG_MU2-ESP_v10e
18
Circuit Design, Inc.
OPERATION GUIDE
■
2.2.13 Other functions panel
On this panel it is possible to change the channels within the system and transmit test data.
7
5
8
6
9
10
13
11
12
3
4
2
1
[1] Channel changing panel
It is possible to change the channels of MU-2-R units in the system at the same time. Before changing the
channels, set the routing information on the route setting panel. This function is not guaranteed to change the
channels without fail. Exercise prudence when changing channels. For example, if changing channels fails when
changing all channels at the same time, first check which stations you can communicate with, then set the route
information again and change the channels.
[2] Changed channel
Sets the channel to change.
[3] Fix in EEPROM
Check this to fix the changed channel in the EEPROM.
[4] Route test button
Tests whether the current system is linked normally before changing the channels.
[5] Result
Shows the result of the route test. If the route is normal, the channel changing buttons are enabled for 3 seconds
only. Change the channels within this time.
[6] Button for changing all station channels
Changes the channels of all stations in the system.
[7] Button for changing the target station channel
Changes the channel of the target station.
[8] Button for changing the source station channel
Changes the channel of the source station.
[9] Help
Help for the other functions panel.
[10] Start/stop button
Starts/stops transmission of the command string.
[11] Interval setting
Approximate transmission time t with the standard protocol can be calculated using the following formula in
accordance with the number of transmission characters;
t=2.08ms*n+100ms
