CIMCO OXE Diesel 125 HP, Руководство по установке

Страница: 13 / 84

13
OXE 125/150/175/200 HP INSTALLATION MANUAL
DIESEL FUEL
The composition of the fuel is vital for operation of the OXE diesel engine, its
service life, and emissions. To meet the performance specified and to run the
boat cleanly and quietly, it is important that fuel as recommended in table
Recommended fluids and grease
is used.
If national emission regulations permit, OXE diesel engines can be operated on
commercially available diesel fuels with less than 0.05% sulfur content.
Fuel sulfur content ≤0.05% (≤500 ppm) >0.05% - 0.5% (>500-5000 ppm
2)
)
Engine oil change intervals 200 h or one year 100 h or one year
1)
1) If the sulfur content is higher than 0.05%, the intervals between engine oil changes should be halved
or determined by frequent oil sampling.
2)
If the sulfur content is higher than 0.1% an engine lubrication oil with suitable TBN shall be used.
NOTE! Do not use fuel with more than 0.5% sulphur content!
Using fuel with high sulfur content will increase the OXE diesel engine’s emission
levels and cause excessive wear and shorter life time.
Large differences in composition occur in local fuel specification. This can result in
higher fuel comsumption, higher emissions and less power output.
ENGINE OIL VISCOSITY
Select viscosity according to diagram below.
The temperature values refer to stable ambient temperatures.
AVOIDING FUEL FLOW RESTRICTIONS
!
WARNING
Adding additional components to the fuel supply system such as filters,
valves, fittings, etc. may restrict the fuel flow. This could cause engine
stalling at low speed, and/or a lean fuel condition at high RPM, that could
cause engine damage.
IMPORTANT INFORMATION