Chrysler Stratus LHD 1997, Интерактивное электронное руководство по эксплуатации

Страница: 150 / 1534

(2) If vehicle is equipped with an automatic trans-
mission remove the shift knob from the shifter. The
gear shift knob is attached to the shifter using a set
screw (Fig. 136). Access to the set screw is from the
front of the shift knob and is removed using a 2 mm
allen wrench (Fig. 136).
(3) If the vehicle is equipped with a manual trans-
mission remove the gearshift knob and shifter boot
using the following procedure.
•
Push shifter boot down to expose clips on gear-
shift knob and roll pin on shifter handle (Fig. 137).
•
Pry the clips on the shifter knob away from the
roll pin in the shifter handle using a flat blade pry
tool (Fig. 137).
•
Remove the shifter knob from the shifter handle,
by pulling the shifter knob straight up (Fig. 138).
•
Remove the shifter boot from the center console.
Shifter boot is removed by squeezing the bezel
together at the base of the shifter boot and pulling
upward on the boot (Fig. 139).
(4) Remove the 2 screws attaching the front of the
center console to the gear selector or shifter (Fig.
140) or (Fig. 141).
Fig. 136 Shift Knob Retaining Screw
CENTER CONSOLE ALLEN WRENCH SHIFT KNOB
Fig. 137 Gearshift Knob
KNOB CLIPSBOOT
Fig. 138 Gearshift Knob Removal
SHIFTER KNOB SHIFTER HANDLE
Fig. 139 Boot Removal
SHIFTER BOOT SHIFTER HANDLE
Fig. 140 Center Console Front Attaching
Screws(Automatic)
PARK BRAKE HAND LEVER
GEARSHIFT MECHANISM ATTACHING SCREWS CENTER CONSOLE
JA
BRAKES 5 - 55
REMOVAL AND INSTALLATION (Continued)