Chrysler Stratus LHD 1997, Интерактивное электронное руководство по эксплуатации

Страница: 967 / 1534

(2) Install cover and tighten screws to 12 N·m (105
in. lbs.)
(3) Install relief valve, spring, gasket and cap as
shown in (Fig. 100). Tighten cap to 41 N·m (30 ft.
lbs.)
TIMING BELT INSPECTION
(1) Remove the upper left timing belt cover (Fig.
104).
(2) Inspect both sides of the timing belt drive &
back. Replace belt if any of the following conditions
exist.
•
Hardening of back rubber back side is glossy
without resilience and leaves no indent when pressed
with fingernail.
•
Cracks on rubber back.
•
Cracks or peeling of canvas.
•
Cracks on rib root.
•
Cracks on belt sides.
•
Missing teeth.
•
Abnormal wear of belt sides. The sides are nor-
mal if they are sharp as if cut by a knife (Fig. 105).
(3) If none of the above conditions are seen on the
belt, the belt cover can be reinstalled.
VALVES, SPRINGS, SEATS AND GUIDES
(1) Check valve stem tip for pitting or depression
at point A (Fig. 106).
(2) Check for wear and ridge wear at Point B.
Fig. 102 Checking Rotor End Clearance
0.04 TO 0.09 mm (0.0015 TO 0.0035 INCH)
Fig. 103 Inner and Outer Rotor Alignment Marks
ALIGNMENT MARKS
Fig. 104 Timing Belt Covers
UPPER RIGHT TIMING BELT COVER FASTENERS UPPER LEFT TIMING BELT COVER FASTENERS LOWER TIMING BELT COVER FASTENERS ENGINE BRACKET FAS- TENERS
Fig. 105 Timing Belt Inspection
PEELING TOOTH MISSING AND CANVAS FIBER EXPOSED RUBBER EXPOSED CRACKS PEELING ROUNDED EDGE ABNORMAL WEAR (FLUFFY STRAND)
9 - 130 2.5L ENGINE
JA
CLEANING AND INSPECTION (Continued)