Christie CP2415-Xe, Инструкция по установке и настройке

Страница: 24 / 48

Connecting power
Connect the projector to the power source.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! A dedicated, protected ground or earth wire must be installed on the product
by Christie qualified technicians or electricians before it can be connected to power.
• SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
• FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
• SHOCK HAZARD! The optional UPS power cord must be inserted into an outlet with grounding.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
• The appliance coupler and main power supply plug must be easily accessible for disconnecting
the product from the power source.
Caution! If not avoided, the following could result in minor or moderate injury.
• Only Christie qualified technicians are permitted to open product enclosures.
• Install the product near an easily accessible AC receptacle.
• For products containing surge suppressors, you must adhere to the installation and power
requirements.
Installation and power requirements
The protected earth wire must be green/yellow 12 AWG minimum.
Use a 20A branch circuit breaker for Input A or 200-240 V main inlet.
The dedicated protected earth wire can only be installed by a Christie accredited service technician or
an electrician.
In all countries with IT power distribution systems, a dedicated protected earth wire must be installed
on the projector before it can be connected to power. To connect the projector to an IT power
distribution system, the building ground must be connected to the external ground lug next to the AC
receptacle on the rear corner of the projector.
1. If the projector is operating, turn it off and disconnect it from AC power.
2. Connect one end of the projector power cord to the AC receptacle on the lower-left rear corner
of the projector and then connect the other end of the power cord to an AC receptacle.
3. If using an Uninterrupted Power Supply (UPS) to power the main electronics, move the AC
switch to A+B mode and connect the power cord provided with the UPS to the B outlet.
Installation and setup
CP2415-Xe Installation and Setup Guide 24
020-103584-02 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.