Christie CP2230, Руководство по обслуживанию

Страница: 95 / 150

Section 5: Parts and Module Replacement
CP2230 Service Manual 5-35
020-100562-06 Rev. 1 (05-2016)
5.12.6 Dolby
®
3D System
For information on how to install Dolby
®
3D kits,
refer to the instruction manual supplied by Dolby
®
.
Be aware that in order to install this system the M4
screw located behind the cardcage must be
removed. (
Figure 5-50 ) This screw secures the two
firewalls and must be removed in order to create a
gap for the cable to run to the side break out panel.
To remove the screw, use the 3mm hex driver
provided with the projector.
5.13 Lamp Compartment
5.13.1 Anode Yoke
The anode yoke is located directly in front of the reflector and its position is adjustable depending on the lamp
being installed.
(Estimated Replacement Time: 4 minutes)
1. Open the lamp door. Refer to 5.5.7 Lamp Door, on page 5-8 .
2. Remove the lamp (if installed). Refer to 5.13.5 Lamp Replacement, on page 5-38 .
3. Using a 5mm hex key, remove the two screws and lock washers from the yoke base. ( Figure 5-51 )
Figure 5-50 Remove Screw Behind Cardcage
Figure 5-51 Front of Lamp Compartment