Christie CP2230, Руководство по обслуживанию

Страница: 104 / 150

5-44 CP2230 Service Manual
020-100562-06 Rev. 1 (05-2016)
Section 5: Parts and Module Replacement
5.13.9 Reflectors (Including Heat Dump)
In the event of a lamp explosion, both glass reflectors will be permanently damaged and need replacement. It is
also likely that the metal reflector shield for the rear reflector will be damaged as well.
(Estimated Replacement Time: 90 m 10 minute LampLOC™ Alignment)
1. Open the lamp door. Refer to 5.5.7 Lamp Door, on page 5-8 .
2. Remove the lamp (if installed). Refer to 5.13.5 Lamp Replacement, on page 5-38.
3. Remove the front top lid. Refer to 5.5.1 Front Top Lid, on page 5-6 .
4. Remove the rear top lid. Refer to 5.5.11 Rear Top Lid, on page 5-10 .
5. Remove the thermal sensor harness and interlock harness from the exhaust interlock assembly.
6. Using a 7mm nut driver remove the nut inside the housing before removing the screw on the external metal
duct plate, shown in Figure 5-63 .
Figure 5-63 Remove External Metal Duct
7. Use a 3mm hex key to remove the six other screws on the duct. ( Figure 5-64 )
Figure 5-64 Remove Screws Securing Duct
8. Remove the douser assembly. Refer to 5.13.4 Igniter, on page 5-37 .